Ormerod 2 Hot end

From Replikeo Wiki
Jump to: navigation, search
thumb
  • PTFE 4mm
thumb

Trim edges
Use pencil sharpener

thumb

Screw by hand the brass parts

thumb
thumb Use drill bit 2mm to clear the PTFE tube
thumb
thumb
  • PTFE 3mm
thumb Cut the proper size with utility knife
thumb
thumb
thumb Use 1.75mm filament to check the inner diameter of the PTFE tube
thumb
thumb Tighten
thumb Tighten
thumb
thumb
  • 2x M3x40mm cap screws
thumb (Plastic parts have been replaced by acrylic part)
thumb
thumb
  • 2x M3x40mm cap screws
thumb
thumb
  • Hot end thermistor
  • Heatshrink PTFE
thumb
  • Hot end thermistor
  • Heatshrink PTFE

Leave 4mm on each side
Use lighter to shrink PTFE tube

thumb
thumb
  • Cable tie
thumb
thumb
  • Cable tie
thumb
  • 2x M3x16mm cap head screws
thumb
  • 2x M3x16mm cap head screws
thumb
thumb
  • Tighten
thumb